August 22, 2019

ASTM D Standard Test Method for Ball-Pan Hardness of Activated Carbon. Standard Test Method for Ball-Pan Hardness of Activated Carbon. Status: Withdrawn · Replaced by: ASTM D Buy this standard. Price: SEK. PDF. D()活性碳的球盘硬度的试验方法 – Designation: D Referenced Documents ASTM Standards: B 19 Speci?cation for.

Author: Nikonris Kazibei
Country: South Africa
Language: English (Spanish)
Genre: Personal Growth
Published (Last): 5 June 2004
Pages: 209
PDF File Size: 20.6 Mb
ePub File Size: 13.72 Mb
ISBN: 418-1-56018-290-5
Downloads: 23595
Price: Free* [*Free Regsitration Required]
Uploader: Shasar

BoxGastonia, NChas been found to be satisfactory.

ASTM D3802 – 16

Obtain at least mL of material within the nominal mesh size range. Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm. Humidity effects during a given test will largely cancel out if no change in humidity occurs between 9. Weigh to the nearest 0.

The value of H2 gives the upper limit of hardness, if we ignore the effects of humidity. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.

ASTM D – 16 Standard Test Method for Ball-Pan Hardness of Activated Carbon

Table 1 lists the hardness test sieve corresponding to each minimum nominal sieve. Current edition approved June 29, At the end of d38802 period, the amount of particle size degradation is determined by measuring the quantity of carbon, by weight, which is retained on a sieve whose openings are closest to one half the openings of the sieve that de?


Precision and Bias Place the hardness test sieve on top of the receiving pan. One supplier tested 31 samples of a single grade of carbon and obtained an average hardness of It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Fit the cover plate aetm a cork stopper which extends from 3.


Pour the screened and weighed sample into the d802 pan and add the steel balls. Discard the fractions above the larger and below the smaller nominal particle size. Apparatus and Materials 6. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.

A number in parentheses indicates the year of last reapproval. This standard is subject to revision at any time by the responsible technical committee and must be reviewed every?

Shake with the hammer operating for 10 min 6 10 s. A superscript epsilon e indicates an editorial change since the last revision or reapproval. Conceding the fact that the test does not actually measure in-service resistance to degradation, it can be used to establish the comparability of lots ostensibly of the same grade of carbon.


The extra sieves, in this case, serve only to form a stack which? None of these has proved completely satisfactory for all applications, and all have been questioned by ASTM Committee D on Activated Carbon as tests for establishing degradation resistance.

Asttm the bottom stops to give a clearance of approximately 1.

Standard Test Method for Ball-Pan Hardness of Activated Carbon

Summary of Test Method 4. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters.

Use additional material obtained as in 9. Tyler Model SB, available from W. If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Sstm, at the address shown below.

Sieves shall be calibrated at reasonable intervals in accordance with the procedure described in Speci? The adhesion of material to sieves, brushes, etc.